Flying Probe - Indirect Testing vs. Military


Reading time ( words)

Introduction

The use of flying probe testers has become increasingly popular in recent times, mainly due to the affordability of the equipment and also the reduced cost of testing, as no dedicated or “bed of nails” fixture is required. When using flying probes to test military product, one must be diligent to make sure the test method is allowable. Grid test machines provide full net to net testing for isolation of all nets and full continuity of individual nets.  This is referred to as full simultaneous test.  When a flying probe is used there are two modes of operation: Direct or indirect.

Direct Testing

When a direct test is used the machine will test every board in resistance mode, meaning that every net will be resistively tested for both opens and shorts. Each board will take the same time to test. When the isolation (shorts) test is performed, nets will be tested using an adjacency window. This is different than a bed of nails whereby which each net is tested simultaneously to all other nets using the voltage and isolation resistance thresholds. With a flying probe only nets within the adjacency window are tested to others. Industry accepted practice for this adjacency window is 0.050” (1.27 mm). Also to be considered is the type of adjacency used.  Standard practice is X,Y adjacency or “line of sight,” meaning only on the same layer. If Z-axis adjacency is added, the adjacency window becomes three-dimensional and isolation testing is done not only on the same layer, but within the adjacency window on layers above and below.

Read the full column here.


Editor's Note: This column originally appeared in the June 2014 issue of The PCB Magazine.

Share




Suggested Items

Millennium Circuits on The Move

10/31/2022 | Andy Shaughnessy, Design007 Magazine
I recently met with Daniel Thau, CEO of Millennium Circuits Limited, at PCB West. This Pennsylvania-based PCB distributor has been on an expansion path lately, so I asked Daniel to introduce us to MCL and explain where the company is headed. As Daniel says, it’s all about impacting the world in a positive way.

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

01/21/2022 | Nolan Johnson, I-Connect007
Next week, we’ll be in San Diego. In fact, I fly down tomorrow morning to start preparations, along with most of the I-Connect007 team. The weather forecast says to expect sunny, with the occasional cloud, all week, with daytime temperatures around 70 degrees. That’ll be nice, as I’m sure COVID-related social distancing guidelines will encourage us to socialize outside as much as is feasible.

Test and Inspection: Competitive Advantage and Cost of Doing Business

12/08/2021 | Nolan Johnson, I-Connect007
In this interview, Charlie Capers of Zentech breaks down the changing requirements he’s seeing in test and inspection in the industry, and the growing importance of investing in testing for the future growth and success of your company. According to Capers, "When you collect statistics on defects, you will start to see a trend that says, for example, we’ve got a lot of shorts and opens, meaning that our solder paste process is not tight. If you’re collecting statistics and really studying them, you will see trends in your processes."



Copyright © 2022 I-Connect007 | IPC Publishing Group Inc. All rights reserved.