Supplier Selection Key to Assembly Reliability


Reading time ( words)

Defining terms is always a good point to start, and from a practical standpoint, reliability can be simply defined as performance to both the design intent for the expected life cycle of the product.

When asked to discuss supply chain strategy, EMS and OEMs often respond with something like, “Yes of course, we have a purchasing department.” Supply chain management has progressed far beyond the old school purchasing mentality to become a key component of the modern business organization. We are all just pieces in the supply chain puzzle that is responsible for getting the ultimate customer’s product to market.

The first step in developing an SCM program is to identify all purchased materials (and services) into two categories, standard and critical. Suppliers of critical materials are the ones that need to be controlled; you probably don’t want to spend too much time managing your supplier of stationary and paperclips. A raw PCB supplier is a perfect example of a critical material, both from a technology complexity standpoint as well as a risk level. It only takes one defective $25 printed circuit board to destroy $2,500 worth of perfectly good electronic components.

Qualification Criteria

Strategically, deciding how to qualify new suppliers is the most critical step in the process. Of course, there must be an overriding strategy governing supplier identification and selection, but that would be a whole other column. The underlying tool should be an audit/survey that measures the quality system, financial viability and technology. Audits are frequently based on ISO 9000, which would be preferable if ISO registration is another qualification criterion (which is highly recommended). There should be a re-audit frequency established and some provision for the supplier to provide demonstration of continued capability for the time period between audits. This could be in the form of quarterly Cpk reports, ISO surveillance audit summaries, etc.

What is found too often are that suppliers have been grandfathered onto an AVL because they have always supplied materials, and that no one has ever audited the facility. Or, the only existing control is a self-audit that the supplier completes with no verification (which is probably ok since we all know that no one ever embellishes on their capabilities when filling out one of these!).

Read the full article here.


Editor's Note: This article originally appeared in the January 2014 issue of SMT Magazine.

Share

Print


Suggested Items

Research and Development Leads to Biogreen Coatings

11/29/2021 | Nolan Johnson, I-Connect007
In the November 2021 issue of SMT007 Magazine, we featured a pre-productronica interview with Phil Kinner of Electrolube, who shared a preview of the company’s newest products that the company planned to launch at the show in Munich. "This is the first show that we’ve been to in a while, and we have a couple of new products we are launching," said Kinner. "One is a thermal gap filler, designed in China by our Chinese team with a thermal conductivity of 6 watts per meter K, which is really decent. We also have a new conformal coating with a high degree of bio-renewable source materials."

Northrop Grumman: 3D Nanomaterials May Counter Gaps in Additive Supply Chain

10/22/2020 | Andy Shaughnessy, Design007 Magazine
The best technology is dead in the water if your domestic supply chain won’t support it. That was just one of the takeaways from Dr. Judy Dickson’s talk during the SMTA Additive Electronics TechXchange. In her presentation, titled “Advanced PWBs: A Collaboration Between Design, Operations, and the Supply Chain,” Dickson, a senior principal systems engineer at Northrop Grumman Mission Systems, laid out the many challenges her department faces in fielding HDI advanced packaging into the next decade. Most of these challenges are related to sourcing the necessary materials in the U.S.

Increase Traceability, Prevent Counterfeiting

08/25/2020 | I-Connect007 Editorial Team
Michael Ford, senior director of emerging industry strategy for Aegis Software and I-Connect007 columnist, speaks about the increasing importance of traceability in manufacturing and throughout the supply chain, including how it affects such areas as counterfeit components and inventory management.



Copyright © 2021 I-Connect007. All rights reserved.