UPC Creates Solar Cells with Record Energy Performance of 22%

Reading time ( words)

Researchers at the Department of Electronic Engineering of the Universitat Politècnica de Catalunya (UPC) have obtained a record efficiency of 22% by creating silicon solar cells that incorporate a surface treatment called black silicon on the front of the cell. This technique nanostructures the surface with a dry chemical attack that results in small conical tips at the nanometric scale. 

Incorporating black silicon reduces the loss of energy caused by the reflectance of solar cells to almost zero. This significantly increases the yield, by almost 4% compared with traditional solar cells. In fact, it is called black silicon because, at first glance, the treated surface is black (and does not reflect light), whereas standard cells are blue. This extra improvement in efficiency would allow a refrigerator, for example, to run for a day in a photovoltaic system composed of a 5 m2 panel.

Solar cells are the main element of solar panels, which are installed to capture sunlight and produce electricity from it. Generally, to ensure that they reflect as little light as possible and thus prevent energy loss, solar cells are textured using an alkaline bath that forms a rough surface on which pyramids are randomly distributed. This technique makes the cells thicker because it consumes a significant amount of silicon in the process. Black silicon, however, allows very thin silicon cells to be used, lowering production costs and saving silicon.

An added advantage achieved by researchers from the UPC and Aalto University in Finland is that, given the ability of black cells to capture solar radiation from lower angles, more electricity can be generated during a longer period throughout the day compared with traditional cells. In Finland this feature is very important, because the sun shines from a low angle for most of the year and it has been demonstrated that cells made with black silicon generate more electricity than traditional cells that have the same degree of efficiency.

According to the UPC researcher Pablo Ortega, "within about three to four years it will be feasible to apply black silicon in the solar panel industry and the market in general."



Suggested Items

CES 2021 Coverage: A Virtual Show Floor

01/17/2021 | Dan Feinberg, Technology Editor, I-Connect007
I write this on the final day of CES 2021, and I expect CES will never be the same. It will not revert back to what it once was. I also cannot imagine it stays a totally virtual show; in doing so, I feel it would fail. Does that mean I think the 2021 show was a failure? No, not at all. In fact, it was a very good event, particularly in light of the medical and political pandemic that we have been enduring.

Requirements of Being a MIL-certified Shop

11/12/2019 | Barry Matties, I-Connect007
Barry Matties speaks with American Standard Circuits’ VP of Business Development David Lackey, who has nearly 40 years of experience producing PCBs for the mil/aero market. David talks about what it’s like being a MIL-certified shop and the stringent quality and reporting requirements that it entails.

Intelligent Healing for Complex Wounds

05/21/2019 | DARPA
Blast injuries, burns, and other wounds experienced by warfighters often catastrophically damage their bones, skin, and nerves, resulting in months to years of recovery for the most severe injuries and often returning imperfect results.

Copyright © 2021 I-Connect007. All rights reserved.