Avoid Overload in Gain-Phase Measurements


Reading time ( words)

Today, most of our printed circuit boards have at least a few DC-DC converters, and some boards have many. We have a large choice when it comes to deciding what to use: we can design and build our own converter from discrete parts (called voltage regulator down or VRD) or we can buy one of the off-the-shelf open-frame or fully encapsulated voltage regulator modules (VRM). 

For low currents we can use linear regulators; for medium and high current we are better off using a switching-mode topology. Whatever circuit suits best our needs, chances are that we want to keep the output voltage regulated against changes in input voltage and load current, which in turn calls for one or more internal control loops.

There is a well-established theory to design stable control loops, but in the case of power converters, we face a significant challenge: each application may require a different set of output capacitors coming with our loads. Since the regulation feedback loop goes through our bypass capacitors (shown as a single Cout in Fig. 1), our application-dependent set of capacitors now become part of the control feedback loop. Unfortunately, certain combination of output capacitors may cause the converter to become unstable, something we want to avoid. This raises the need to test, measure and/or simulate the control-loop stability.

fig1-istvan-0615.jpg

To read this column, which appeared in the June 2015 issue of The PCB Design Magazine, click here.

Share




Suggested Items

DownStream Flexes in Rigid-Flex

11/14/2022 | Andy Shaughnessy, Design007 Magazine
During PCB West, I caught up with DownStream Technologies co-founder Joe Clark and Senior Product Marketing Manager Mark Gallant. We discussed some of their latest tool updates, including a greater focus on bringing post-processing functionality, such as inter-layer analysis capability, to rigid-flex circuits. Joe also offered a look at global design trends going into 2023, as more engineers take on PCB designer roles while senior designers are retiring.

Sunstone’s Matt Stevenson Shares Insights From New PCB Design Book

10/27/2022 | Nolan Johnson, I-Connect007
There’s designing the “perfect” circuit board and then there’s designing a board that is “perfect for manufacturing.” While seasoned designers and design engineers understand many of the nuances, PCB fabricator Sunstone Circuits has just published a new book specifically for new designers who have the knowledge of design but are still learning what it means to get the board manufactured. Sunstone’s Matt Stevenson takes the reader through a series of situations that should help clarify what’s happening in the fabrication process and how to adjust a board design to be better suited for manufacturing.

Forming Standards for Ultra HDI

10/25/2022 | Andy Shaughnessy, Design007 Magazine
To get the latest news about ultra high-density interconnections (UHDI), we checked in with Jan Pedersen, NCAB Group’s director of technology. Jan is co-chair of IPC D-33AP, and a great source of overall DFM expertise as well. We asked him to give us a snapshot of UHDI in the industry, where we’re headed, and what this means to PCB designers.



Copyright © 2022 I-Connect007 | IPC Publishing Group Inc. All rights reserved.